APPLICATION & MAINTENANCE

Best results are obtained when the finish is applied to surfaces which are 60 o F. or warmer. Remove old finish or wax with one of Perma's high quality finish strippers. Mop or vacuum up the stripping solution and rinse floor thoroughly with clean water. Optimum appearance and gloss is obtained with five coats of finish. Apply thin even coats, allowing the finish to dry depending on humidity and temperature for approximately 30-45 minutes between coats.
Effective recoating of existing finish may be achieved by vacuuming or dry mopping the floor to remove any loose dirt or dust. Wash the floor with #127 Tops Neutral Cleaner to remove fine dirt and soil, and allow it to dry. Apply thin even coats, allowing the finish to dry for approximately 30-45 minutes between coats.
A routine maintenance program will provide the most satisfactory gloss retention and wear characteristics in any floor coating. Floor surfaces should be vacuumed, or swept with a clean dry mop treated with #135 Aqua Treat, water based mop treatment, daily to remove abrasive loose dirt and sand. Damp mop floors with #127 Tops Neutral Cleaner every two or three days to remove soil, salt, and film deposits which can degrade a coatings gloss. Perma product #66 High Speed Maintainer may be periodically substituted for neutral cleaner, and high speed burnished to restore finish gloss. Floors may also be buffed or high speed burnished to restore the gloss and extend the time between recoating. Use #6 One Step Spray Buff for standard speed buffers (175-300 Rpm), or #68 Cream Buff for high-speed and ultra-high-speed burnishing machines (1000-3000 Rpm).

SPECIFICATIONS
Nonvolatile Solids 22 +- 0.6%
Total Active 30%
pH 8.2 - 9.0
Gloss 60 0 91 @ 5 coats
Color Translucent white
Weight Per Gallon 8.55
Slip Resistance (ASTM) 0.5 Minimum, Average= 0.6
Stability 2 year minimum
at room temperature
Freeze/Thaw Stability 3 cycles minimum
Drying Time 30 - 35 minutes
Water Resistance Excellent
Gallon Coverage (Feet 2 ) 2000 + 10%
Removability (Gardner) 75 cycles maximum


SAFETY INFORMATION
Health 1
Flammability 0
Reactivity 0
Personal Protection B


This finish is not a hazardous mixture, as defined in 29 CFR 1919, 1200 and M.G.L. c. 111F. Safety glasses and gloves should be worn during application and handling. If ingested drink milk, water, fruit juice, and induce vomiting with oil of ipecac. In the event of eye contact flush area with water for 15 minutes. Consult with a physician. For detailed information consult MSDS sheet.

Perma Home Page                 Cutting Edge Resilient Tile Floor Finish