APPLICATION AND MAINTENANCE
For initial application remove any existing finish with #118 Eliminator. Scrub the
floor surfaces with a deep cleaning pad (green or brown), or a good quality nylon brush
for textured surfaces. Vacuum or mop up the scrubbing solution and rinse the floor with
clean water. Optimum results are obtained by applying two or three thin coats of Syn Coat,
allowing at least one hour drying time between coats.
For irregular surfaces dilute the finish with equal amounts of water and apply a
light coat with a pressurized or airless sprayer.
Regular maintenance will extend the life of Syn-Coat. Sweep, or dry mop with a mop
treated with #135 Aqua Treat water-based mop treatment, or vacuum, at least daily or more
often as necessary. Follow by damp mopping with #127 Tops Synthetic Neutral Cleaner, or
#70 Constant Traction. Avoid using harsh cleaners and oil-based mop treatments. Do not use
high speed burnishing machines on these types of flooring.
| Nonvolatile Solids | 12 - 13% |
| Total Active | 15 + 0.5% |
| pH | 8.0 + 0.5 |
| Gloss | 80+ |
| Color | Light Green |
| Weight Per Gallon | 8.4 |
| Slip Resistance (ASTM) | Exceeds 0.5 |
| Stability | 1 year minimum at room temperature |
| Freeze/Thaw Stability | 3 cycles minimum |
| Drying Time | 20 minutes |
| Water Resistance | Excellent |
| Coverage | 1000-1500 Ft. |
| Removability (Gardner) | 70 maximum |
| Health | 1 |
| Flammability | 0 |
| Reactivity | 0 |
| Personal Protection | B |
This material is not a hazardous mixture, as defined in 29 CFR 1919, 1200 and M.G.L. c.
111F. Safety glasses and gloves should be worn during application and handling. If
ingested, drink milk, water, fruit juice, and induce vomiting with oil of ipecac. In the
event of eye contact flush area with water for 15 minutes. Contact a physician. For
detailed information consult MSDS sheet.