APPLICATION AND MAINTENANCE

Solvent Liquid Wax may be used as is from the container, or if a more liquid consistency is desired the can may be placed on a radiator or placed in warm water for several minutes. Sweep or vacuum floor surfaces to remove grit, sand, or dirt. Using a low-speed buffing machine (175-300 Rpm) and a #2 steel wool or spray buffing pad, apply a small amount of the solvent liquid wax directly to the floor surface. Using the buffing machine spread a very thin even coat of wax on the floor. For small areas, or those inaccessible with a buffing machine, the wax can be applied by hand using #2 steel wool, a soft cloth, or lambs wool applicator. The wax will dry to a satin sheen in approximately 15 or 20 minutes. The waxed surface can then be polished with a buffing machine and soft polishing brush, polishing pad, or by hand with a soft cloth or brush to a hard, lustrous shine. Apply additional coats of wax until desired gloss and level of protection is obtained.

DANGER: Harmful or Fatal if Swallowed. Contains Stoddard Solvent CAS# 8052-41-3, and Gum Turpentine CAS# 8006-64-2. If Swallowed, Do Not Induce Vomiting. Call Physician Immediately.
COMBUSTIBLE: Keep away from heat and open flame. Close container after each use. Provide adequate ventilation. For complete information consult MSDS sheet.

Perma Home Page                Wood Floor Finishes and Coatings